Clona Analizor logic Saleae 24Mhz 8 canale

Introduction

This is a very affordable 24Mhz 8 Channel USB Logic analyzer. This is a hobbyist level analyzer, ideal for testing your Arduino or other hobbyist microcontroller's communications. A logic analyzer is a must have tool for any serious electronics hobbyist. With a logic analyzer it is possible to see a visual representation of the zeros and ones that are flashing by between two components. A logic analyzer is different from an oscilloscope because the analyzer allows you to capture the data on a PC for a more detailed analysis of the data which is being transmitted and received. This logic analyzer supports 10 different communications standards (see Specifications below). with 8 channels it will allow you to monitor upto 8 differnet wires. So on an Arduino you could monitor the Serial port (tx/Rx pins), the I2C port (pins A4, A5), and the SPI port (pins 10, 11, 12, and 13) all at the same time.

Specifications

8 Channels
Supports triggering (rising, high, falling, low)
Up to 24Mhz sampling
Up to 10 Billion samples
Max Voltage: 5.25Vdc
supports:

• CAN
• DMX-512
• I2C
• I2S/PCM
• Manchester
• 1-Wire
• Async Serial
• Simple Parallel
• SPI
• UNI/O

Fully compatible with the Saleae Logic software

Connection diagrams

I2C

config:

Serial TTL

config:

SPI

config:

• NOTE: It does not matter to which pin on the analyzer you connect each signal. This will be configured in the logic analyzer software later, as shown in the screen shots above.

Shipping List

Logic Analyzer (1 unit)
USB Cable (1 unit)
Jumper wire (10 units)

Saleae 24MHz 8Channel Logic Analyzer Latest support 1.1.15

Speedy 24MHz
Logic samples each channel at up to 24M times per second. A large fraction of practical, real world applications run at less than 10MHz, and Logic is ideal for these.

8 Channels
Logic has 8 inputs -- it can monitor 8 different digital signals at once. For many modern microcontroller-based designs, this is plenty.

10 billion samples
Logic can save as many as 10B samples, letting you to capture even the most elusive events. No more dealing with frustratingly small sample buffers.

Voltage range
Logic accepts voltages from -.5V to 5.25V, and has standard CMOS thresholds of .8V for logic low, 2.0V for logic high. Input impedance is approximately 1MΩ paralleled by 10pF (see more specs)

Protection
Logic’s inputs are protected against overvoltage conditions via current-limiting resistors and ultra-low-capacitance diode clamps. A resettable fuse protects the USB ground return line to augment the USB host’s existing protection.

Pachetul include:

1 x Analizor logic (negru)

1 x cablu USB (negru)

10 x cabluri de test