Nokia 5110 LCD Module White Backlight For Arduino
-
Produs:Nou, Fără garanție
-
Numar articol:174002131
-
Disponibilitate:Indisponibil
-
Preț:16,00 Lei
-
Anuntul a expirat la:03.09.2015, 15:41
-
Ai o nelamurire?
-
Vandut de:
-
Vinde si tu:Pune in vanzare un produs ca acesta
-
Optiuni:
Descriere
Vânzatorul este direct răspunzator pentru produsul afișat în această pagină.
Disponibilitate: Indisponibil - Vezi produse similare
Specificatii
Nokia 5110 LCD Module, Arduino
Pin Connections
1. RST--------- reset.
2. CE------------chip selection.
3. DC-----------data/commands choice.
4. DIN-----------serial data line.
5. CLK------------serial Clock Speed.
6. VCC----------Power, 3.3V (Positive).
7. LIGHT--------- backlight control terminal.
8. GND-----------power negative.
Specification:
Power supply voltage: 2.7V- 3.3V
Backlight Power Supply Voltage: 3.3V MAX
43.6mm x 43.1mm(width X height)
84 x 84 dot matrix LCD,can show 4 lines of characters, 12
Characters Per Line
Feature:
Uses Serial Peripheral Interface (SPI) to communicate with the
microcontroller, only 8 signal lines including power and GND.
Support different types of MCU (MicroController Unit) , such as
Arduino, PICAXE, ARM, Raspberry PI etc. Transfer rate up to
4Mbps,can full speed write display data without waiting time.
LCD controller/driver chip has been bound to LCD chip so the
overall footprint of the LCD Module is Kept as small as
possible.
Has TWO Rows where header pins can be soldered for greater
flexibility of use!
Low power supply, the working current in normal situation is lower
than 200μA,and has power-down mode.
Modalitati de livrare si plata
LIVRARE
In Odorheiu Secuiesc
-
- Predare personala in max. 24 de ore
PLATA
- - La predare
- - Ramburs
Politica de retur
- - Produsul nu se poate returna.