MQ-2 senzor gaz Arduino / PIC / AVR / ARM / STM32
Cost unic de transport la toate comenzile acestui vanzator
-
Produs:Nou, Fără garanție
-
Numar articol:170961032
-
Disponibilitate:Indisponibil
-
Preț:
19,99 Lei12,99 Lei -
Anuntul a expirat la:11.12.2018, 11:34
-
Ai o nelamurire?
-
Vandut de:
-
Vinde si tu:Pune in vanzare un produs ca acesta
-
Optiuni:
Descriere
Vânzatorul este direct răspunzator pentru produsul afișat în această pagină.
Disponibilitate: Indisponibil - Vezi produse similare
Specificatii
Item Description |
Features:
Introduce: MQ-2 gas sensor sensitive material used in the clean air low conductivity tin oxide (SnO2). When there is the environment in which the combustible gas sensor, conductivity sensor with increasing concentration of combustible gases in air increases. Using a simple circuit to convert the change in conductivity of the gas concentration corresponding to the output signal. MQ-2 gas sensor high on gas, propane, hydrogen sensitivity of detection of natural gas and other flammable vapors are also very good. This sensor can detect a variety of flammable gas, is a low-cost sensors for a variety of applications. Module Features: Using high-quality dual-panel design, with power indicator and TTL signal output instructions ; The switching signal having a DO (TTL) output and analog output AO ; TTL output valid signal is low . ( Low-level signal when the output light can be directly connected to the microcontroller or relay module ) Analog output voltage with the higher concentration of higher voltage. A gas, natural gas, city gas , smoke better sensitivity. There are four screw holes for easy positioning ; Product dimensions : 32 (L) * 20 (W) * 15 (H) Has a long life and reliable stability Rapid response and recovery characteristics Chip: LM393, ZYMQ-2 gas sensors Working voltage: DC 5V Detection of gas: combustible gases, fumes Detectable concentration :300-10000ppm (flammable gas) Electrical properties: Input voltage : DC5V Power consumption ( current ): 150mA DO output : TTL digital 0 and 1 ( 0.1 and 5V) AO output :0.1-0 .3 V ( relative to pollution ) , the maximum concentration of a voltage of about 4V Special note: After the sensor is powered , needs to warm up around 20S, measured data was stable , heat sensor is a normal phenomenon , because the internal heating wire , if hot is not normal . Wiring: 1, VCC: positive power supply (5V) 2, GND: power supply is negative 3, DO: TTL switching signal output 4, AO: analog signal output Module Applications: Gas may be used in homes and factories leakage monitoring device suitable for the detection of gas, butane , propane , methane , smoke , etc. |
Modalitati de livrare si plata
LIVRARE
PLATA
- - Ramburs cu Garantia de Livrare
Curierul special îți livrează produsul pe care tu îl achiți la primire. Dacă produsul nu este ca în descriere, îți recuperezi banii, inclusiv taxele de transport.
Politica de retur
- - Produsul se poate returna in maxim 3 zile lucratoare
- - Metoda de retur: Ramburs contravaloare produs
- - Costul transportului va fi suportat de catre cumparator
- - Alte detalii: Retur acceptat in conditiile Garantiei de Livrare