Procesor sunet Match - AVLA-DSP incl. EPC 5.2

Procesor sunet Match - AVLA-DSP incl. EPC 5.2
Procesor sunet Match - AVLA-DSP incl. EPC 5.2

Procesor sunet Match DsP incl. EPC 5.2

MATCH DsP with integrated Easy Plug Cable EPC 5.2 for easy installation

Digital 6-channel signal processor with 56 bit DsP
MATCH DsP

Easy to install, easy to adjust - the MATCH DsP is the perfect solution for smaller sound systems, which are driven by the original car radio. Its layout not only allows classical configurations (front L/R, rear L/R + subwoofer) but as well fully active front systems including subwoofer and center speaker. The versatile AUX input manages additional sources.

Nevertheless the reduction to the basics is solely limited to the number of channels - the well-known PC software and the technology inside this stunning device is as perfect as every other product from Audiotec Fischer. 56 bit signal processing, top-notch converters from Asahi Kasei and an uncompromising internal power supply care for outstanding measuring results and exceptional sound quality, both redefining the standards not only in this segment.

Windows interface - communication via UsB 2.0
MicrosD slot to upload DsP settings without having to connect the DsP to a PC
special audio DsP with a resolution of 56 bits - optimized for highest sound quality
Freely configurable inputs and outputs
Graphical 30-band EQ per channel with the fine adjustment of the individual bands in 1/24 octave steps and time correction in 7-mm steps, all established filter characteristics are available and much more
Inputs: 4 x highlevel, 1 x AUX stereo phone jack 3.5 mm, 1 x remote in, 1 x control input, MicrosD and UsB
Outputs: 6 x RCA and remote output
Extremely compact dimensions: 44 x 185 x 100 mm

Inputs: 4 x Highlevel speaker input; 1x Aux stereo phone jack 3,5mm; 1 x Remote In
Outputs: 6 x RCA/Cinch; 1 x Remote Out
Input sensitivity: Highlevel 5 - 1 0 Volts; Aux 100mV
Output voltage: 4 Volts
Frequency response: 10 - 22.000 Hz
signal-to-noise ratio: 105 dB
Distortion (THD+N): < 0,004%
Crosstalk: > 90 dB
Power supply: 9.6 - 18 Volts (5 sec. down to 6 V olt)
DsP resolution: 56 Bit
DsP power: 172 MHz



Power save Mode
The Power save Mode is incorporated in the basic setup. It allows to significantly reduce the power consumption of the amplifiers that are connected to the MATCH DsP once theres no input signal present for more than 60 seconds. Please note that in many up-to-date cars with CAN or any other internal bus structures it may happen that the radio remains invisibly turned on for up to 45 min. even after leaving the car! Once the Power save Mode is active the remote output and therefore the connected amplifiers will be turned off. The MATCH DsP will reactivate the remote output within a second if a music signal is applied. It is possible to either modify the turn-off time of 60 sec. or completely deactivate the Power save Mode via the PC-tool software. In basic configuration the Power save Mode is always activated.


start-stop capability
The switched power supply of the MATCH DsP assures a constant internal supply voltage even if the batterys voltage drops to 6 Volts during engine crank.


The intelligent highlevel input
The 4-channel fully-differential highlevel input is equipped with Audiotec Fischers unique DEP circuit (Diagnosis Error Protection), means that OE car radios with speaker diagnosis function will not generate any undesired error logs if this DsP is connected.

Inputs


4 x High level speaker Input
1 x AUX stereo phone jack 3.5 mm
1 x Remote In

Input sensitivity


Highlevel 10 Volts RMs

Lowlevel 2.5 Volts RMs (only usable with RCA/Cinch adaptor)

Outputs


6 x RCA
1 x Remote out

Output voltage


4 Volts RMs

Frequency response


10 - 22.000 Hz

DsP bandwith


56 Bit

DsP processing power


172 MHz

signal converter


A/D Asahi Kasei
D/A Asahi Kasei

signal-to-noise ratio


105 dB (A-weighted)

Total harmonic distortion (THD+N)


< 0.004 %

IM distortion (IMD)


< 0.008 %

Crosstalk


> 90 dB @ 1kHz

Operating Voltage


9,6 - 18 Volts, short drops down to 6 Volts acceptable

Current draw


< 500 mA

Additional features


Control Input, Micro sD, UsB

Producator:MatchCod:AVLA-DSP incl. EPC 5.2