Amplificator + preamplificator Technics SE-A1000 Reference + SU-C1000 Reference cu vumetre, acumulator nou, poze reale

Technics SE-A1000 Reference + SU-C1000 Reference

Mos-Fet Class AA

Functioneaza perfect,  toate potentiometrele si comutatoarele merg usor, fara caraituri sau alte zgomote! Toate becurile de la panoul cu vumetre functioneaza. Preamplificatorul a primit un acumulator nou, mai bun ca originalul! Mufe RCA aurite atat la amplificator cat si la preamplificator!

Suna foarte bine!

Poze reale, ce vedeti e ce primiti!

Pentru Bucuresti asigur proba la domiciliul meu!

Se livreaza dupa cum se vede in foto 15, cu telecomanda pentru intregul sistem si toate cablurile necesare.

Nu fac schimburi!

Pret fix!

Daca nu aveti minim 10 calificative integral pozitive veti plati in avans transportul, intrebati inainte de a apasa 'cumpara'.

Asigur ambalare foarte buna!

Specificatii:

Technics SU-C1000 Hi-Fi Pre Amplifier    

VGCA (Variable Gain Control Amplifier) satisfies new high fidelity demands of DVD audio
Battery Drive Power Supply keeps AC noise out of the signal path
R Core transformer eliminates magnetic flux leakage
Audiophile quality MASTER Series TA-KEH II electrolyte capacitors for high quality sound
Hi-Fi volume control with high quality sound
Aluminium front panel
Technics Remote Control System designed for high sound quality
7-position inputs selectors (CD, DVD-6ch, Tape 1, e 2/MD, Tuner, Phono, Aux)
Special outputs for Bi-amp connection
Tape monitor switch
Tone controls at VIA TONE position
Balance control
Muting switch (by remote control)
Made in Japan


Technics SE-A1000 Hi-Fi Power Amplifier

Super linearity and super sound quality - MOS Class AA circuit
Audiophile quality TA-KEH II electrolytic capacitors
120w x2 high power output (DIN 4ohms)
Level control on rear panel for gain fine tuning for bi-amp use
Aluminium front panel
Large needle-type power meters
A and/or B speaker selector
Meter light off switch
Headphone jack

MOS class AA amplifier is adopted and high-quality sound-ization is attained by combining the frequency characteristic, the pure Class-A voltage control amplifier which used MOS FET excellent in the linearity, and the current-supply-source amplifier which consisted of bipolar transistors with drive power on a class AA bridge.
The separator which blended the bamboo fiber is adopted as the electrolytic capacitor for smooth of a power circuit. Pure driving force has been conjointly obtained with the enhancement of the aluminum foil and the electrolytic solution which were selected carefully.

The large-sized analog power meter which can carry out a Direct reading from the minute signal of 0.001W is adopted.

The high-density hybrid material which suppresses an oscillation is used for the front panel.

The input terminal in which the gilding treatment was performed is adopted.

The OCC wire rod is adopted as an internal wiring.

The speaker termination corresponding to a banana plug is adopted.

The polar attached-indicator OFC power cord is adopted.

Input sensitivity     1V/33kohm
S/N ratio     98dB(EIAJ)
Frequency response: 5Hz to 70kHz
Total harmonic distortion: 0.01% (20Hz - 20kHz, 8ohms)
Damping factor: 70
Input sensitivity: 1V
Signal to noise ratio: 95dB
Speaker load impedance: 4 to 16 Ohm
Dimensions: 430 x 136 x 344mm
Weight     9.8kg
Made in Japan