DC-DC converter step-up, IN: 5-32V, OUT: 5-50V, ( 2.5A ) 15W

Produsul este nou!

Specificații în limba engleză:

1: The new original XLSEMI chip, eliminate fake, disassemble chip.

 

2: Imported SMD electrolytic capacitors, not accompanied by homemade capacitance.

 

3: Up to 400Khz operating frequency, and LC filter circuit, output ripple is very low.

 

4: Import TDK inductors, the heat and noise to a minimum.

 

6: Input and output three MLCC Multilayer ceramic capacitors, interference enhance stability.

 

7: PCB use kb of A grade sheet material, to prevent cardboard, garbage plate.

 

8: Built-in MOSFET, the LM2577 built-triode say goodbye, can reach 94% efficiency.

 

9: Increased enable the port, you can control whether the boost circuit.

 

10: Dimensions: 49 (L) * 23.4 (W) * 11.4 (H) mm (excluding potentiometer)

 

 

Parameters

 

Module Properties: non-isolated step-up module (BOOST)

 

Input voltage: 5-32V

 

Output voltage: (1) continuously adjustable (5-50V)

 

Output Current: 2.5A (MAX)

 

Input Current: 4A (MAX)

 

Output power: natural cooling 15W, plus heat sink 25W (MAX) real power

 

Maximum output power = input voltage conversion efficiency * 4A *conversion efficiency

 

Conversion efficiency: the efficiency of the measured voltage and current commonly used (hereinafter, for reference only)

 

 A=Input voltage. B=Input Current. C=Output voltage. D=Output Current. E=conversion efficiency 

 

 

 

 

 Operating temperature: Industrial grade (-40 C to + 85 C) (ambient temperature exceeds 40 degrees, lower power use, or to enhance heat dissipation)

 

Full load temperature rise: 45 C

 

Operating frequency: 400khz

 

Load current: 5V turn 12V 15mA, 8.4V turn 12V 7mA, 12V switch 24V 9mA, 12V switch 36V 18mA, 24V switch 48V 9mA, 24V switch 36V 6mA.

 

Load regulation: ± 0.5%

 

Voltage regulation: ± 0.5%

 

Dynamic response speed: 5% 200uS

 

Enable Control Port: Yes, high 1.4V-VIN (ON), low 0-0.8V (OFF), the default high

 

Short circuit protection: None (Please install fuse or protection circuit input)

 

Input reverse polarity protection: None, please with our reverse protection diode board or in the input series.

 

Installation: You can screw (Fixing holes 3 mm), 2 fixing holes

Pachetul conține:
• 1 bucata x DC-DC converter step-up, IN: 5-32V, OUT: 5-50V, ( 2.5A ) 15W

Predare personală în Galați.

Se expediază în toată țara prin Posta sau curierat în sistem ramburs.

• Posta Romană - 10 lei
• FAN CURIER - 17 lei

Trimit în tară si cu verificare colet. La prețul transportului se adaugă 4 lei.

Dacă aveți nelămuriri sau întrebări vă rog nu ezitați să sunați sau să-mi scrieți.