Releu cu telecomanda radio doua relee + 2 telecomenzi 220V 2 canale automatizari porti

Produsul realizeaza doua contacte prin intermediul a doua relee,
este destinat realizarii a diverse automatizari inclusiv actionare
porti, caz in care pot fi necesare si alte componente. Este
destinat cunoscatorilor, nu ofer montaj nici consultanta decat
strict pentru functionarea produsului. Bateriile pentru telecomanda
sunt incluse. Optional se mai pot adauga una sau mai multe
telecomenzi. Kit compus din receptor cu doua canale si doua
telecomenzi 433 Mhz, utila pentru diverse comenzi la distanta /
automatizari porti. Telecomanda are baterie inclusa. Receptorul se
alimenteaza la 220 V curent de mers in gol 6mA si poate comanda max
10 A prin releele incorporata. Temperatura functionare -40 / + 80
gr C. Pot fi setate mai multe moduri de lucru pentru telecomanda
contact permanent sau intermitent. Working Modes explanation:
Momentary Mode: Push the remote button , the relay activates,
release the remote button the relay deactivates. Toggle Mode: Push
and release the remote button , the relay activates. Push and
release the remote button again and the relay deactivates. Clearing
All Stored Transmitters: **Note** After clearing the stored
transmitters, all transmitters will need to be relearned by the
receiver. Push the learning button on the receiver 8 times , and
the codes will be cleared . Learning the transmitter :(momentary
Mode) Programing a 2 button transmitter as momentary mode
transmitter. STEP 1 Push and release the learning key on the
receiver ONCE. Wait for a moment , the LED will turn off ,
indicating you entered the learning state. STEP 2 Push and release
the first button on your transmitter, the LED on the receiver board
will flash on then off indicating the button was learned. STEP 3
Press and release the second button, watching the LED go on and off
again. Wait 3 seconds, the LED will turn on again , indicating
system is ready for use. Learning the transmitter : ( Toggle Mode )
Programing a 2 button transmitter as toggle. STEP 1 Press and
release the learning key on the receiver TWICE. Wait for a moment ,
the LED will turn off , indicating you entered the learning state.
STEP 2 Press and release the first button on your transmitter, the
LED on the receiver board will flash on then turn off. Indicating
the button was learned. STEP 3 Next press and release the second
button, watching the LED go on and off again. Wait 3 seconds, the
LED indicator will turn on again , indicating system is ready for
use **Notice** two button transmitters can only be used as toggle
or momentary. One mode per 2 button transmitter. (Please note: You
let the control panel to learn the remote control, you must press
the "A" and "B" button; Rather than just pressing one of them )
However you can program another transmitter in the other mode.