Releu cu timer programabil 5V-30V micro USB si potentiometru
Cost unic de transport la toate comenzile acestui vanzator
-
Produs:Nou, Fără garanție
-
Numar articol:209513655
-
Disponibilitate:Indisponibil
-
Preț:
28,00 Lei24,00 Lei -
Anuntul a expirat la:06.03.2022, 08:15
-
Ai o nelamurire?
-
Vandut de:
-
Vinde si tu:Pune in vanzare un produs ca acesta
-
Optiuni:
Descriere
Vânzatorul este direct răspunzator pentru produsul afișat în această pagină.
Disponibilitate: Indisponibil - Vezi produse similare
Specificatii
Wide Voltage 5V-30V Trigger Delay Relay Module Timer Module Delayed
On-Delay Switch Button
Module Highlights:
The time can be adjusted by potentiometer to meet your use of most
occasions.
With MicroUSB 5.0V power input, very easy to use.
5 - 30V wide supply voltage.
External trigger and on-board key trigger two ways.
With relay pull indicator.
Anti-interference ability, all kinds of interference relay will not
malfunction, suitable for industrial control.
Module Features:
1. Operating voltage: wide voltage 5 - 30V between any voltage,
MicroUSB and welding terminal two power supply interface
2. Operation mode: After power supply to the module, the state of
module output is: NO (NO) is disconnected from common (COM), NC
(NC) and COM (COM) are on.
(NO) and common (COM) are turned on when the external trigger
terminal (TRIG) gives a low pulse signal, or the trigger key is
touched instantaneously, the relay is sucked and the operation
indicator is on. At this time, the state of the relay output
terminal is: Normally closed (NC) and common (COM) disconnected,
after 0-24 seconds (this time can be adjusted according to your
needs) after the relay disconnect, then the relay back to the state
before the trigger.
3. Time can be adjusted by potentiometer, default 0-24 seconds. If
a longer time is required, replace the larger capacitor (C2) or the
potentiometer. Delay time formula: T = 1.1RC. For example:
capacitor 22uf resistance 1M then T = 1.1 * 0.000022 * 1000000 =
24.2 seconds.
4. With the relay pull light.
5. Module can be controlled: 10A 250VAC (AC), 10A 30VDC (DC) the
following load.
6. With relay freewheeling protection.
7. Module signal side design of the pull-up and filter circuit,
anti-interference ability, suitable for industrial control. Many
manufacturers have optocoupled to add isolation, but the module and
the trigger signal to the ground and not isolated, will not achieve
the anti-jamming effect. After testing and found to improve the
stability of the trigger side to anti-interference, the module
regardless of electromagnetic interference in the environment, or
the power module off the moment, the relay will not produce
malfunction.
8. Size: 5.4 * 1.9 * 1.8cm (L * W * H)
9. Weight: 16g
Applications:
1. Burglar alarm delay, building sound and light switch lights and
so on.
2. On-board equipment connected to the delay to prevent the car
when the ignition is too large burned car equipment.
3. The need to have the order to start the occasion to prevent
multiple devices at the same time start the current is too large to
burn electrical appliances.
Modalitati de livrare si plata
LIVRARE
In Bucuresti
-
- Predare personala in max. 1 zi lucratoare
PLATA
- - La predare
- - Ramburs
Politica de retur
- - Produsul nu se poate returna.