Avem peste 6.000.000 de produse de la magazine si vanzatori profesionisti in Okazii.ro Marketplace
Cos cumparaturi
Favorite
Ai nevoie de ajutor ?
Catalog produse
Toate
 

Touchscreen cu display LCD sticla ecran Apple iPhone 6+ plus alb original

  • Produs:
    Nou, Ofer garanție, Cu factură
  • Numar articol:
    184493799
  • Disponibilitate:
    Indisponibil
  • Preț:
    529,00 Lei
  • Anuntul a expirat la:
    12.05.2018, 18:11
  • Vinde si tu:
    Pune in vanzare un produs ca acesta
  • Optiuni:
    Vezi produse similare

Descriere

Vânzatorul este direct răspunzator pentru produsul afișat în această pagină.

Disponibilitate: Indisponibil - Vezi produse similare

Specificatii

Display cu touchscreen pentru iPhone 6 plus

Acest touchscreen cu display functioneaza doar pe device-ul Apple iPhone 6 plus si nu este compatibil cu device-urile iPhone 6, iPhone 6s sau iPhone 6s plus.

Functia de Touch Id va functiona numai cu butonul original home. Aceasta componenta nu include butonul de home, va trebui demontat de pe piesa veche si montat.


 

Componenta Display - Touchscreen

Culoare: alb

Tip: IPS Retina

Numar culori: 16.7 milioane

Dimensiune ecran: 5.5 inch

Rezolutie: 1080 x 1920

Altele: Multitouch, Ion-strengthened glass, oleophobic coating

Informatii, detalii, montare si demontare service autorizat pentru Display cu Touchscreen iPhone 6 plus:

 

Pasul 1

Image 1/1: Remove the two 3.6 mm Pentalobe screws next to the Lightning connector.

Pasul 2

Image 2/3: Close the handle on the iSclack, opening the suction cup jaws.

Pasul 3

Image 2/2: Peel the two suction cups off your iPhone.

Pasul 4

Image 1/1: Press a suction cup onto the screen, just above the home button.

Pasul 5

Image 1/1: Take your time and apply firm, constant force. The display assembly is a much tighter fit than most devices.

Pasul 6

Image 1/2: Remove the suction cup from the display assembly.

Pasul 7

Image 1/3: Open the display to about a 90º angle, and lean it against something to keep it propped up while you're working on the phone.

Pasul 8

Image 1/2: During reassembly, align the clips just below the top edge of the rear case. Then, slide the front panel upward until its top edge is flush with that of the rear case.

Pasul 9

Image 1/1: One 2.3 mm Phillips #00 screw

Pasul 10

Image 1/1:

Pasul 11

Image 1/1: Take care to '''only''' pry up on the battery connector, and not the socket on the logic board. If you pry up on the logic board socket, you may break the connector entirely.

Pasul 12

Image 1/1: Three 1.2 mm Phillips #00 screws

Pasul 13

Image 1/1:

Pasul 14

Image 1/2: While still supporting the front panel, use a plastic opening tool to disconnect the front-facing camera and earpiece speaker cable connector.

Pasul 15

Image 1/2:

Pasul 16

Image 1/2: When reassembling your phone, the display data cable may pop off the connector. This can result in white lines or a blank screen when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to [guide|29424|disconnect and reconnect the battery connector.|stepid=69596]

Pasul 17

Image 1/2: When reconnecting the digitizer cable, '''do not press the center of the connector'''. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

Pasul 18

Image 1/1:

Pasul 19

Image 1/1:

Pasul 20

Image 1/1:

Pasul 21

Image 1/2:

Pasul 22

Image 1/1: Gently move the spudger across to separate the home button connector cable from the adhesive securing it to the front panel assembly.

Pasul 23

Image 1/2: Do '''not''' push the home button all the way through—you only need to get a corner free, so that you can pry it free with a spudger.

Pasul 24

Image 1/2:

Pasul 25

Image 1/1:

Pasul 26

Image 1/1: The Touch ID function will '''ONLY''' work with your phone's original home button assembly, so you'll need to transfer the home button assembly from your old display assembly to your new display assembly to retain Touch ID.

Modalitati de livrare si plata

LIVRARE

  • Livrare prin Fan Courier 16 lei doar in localitatile de acoperire. Livrare prin Posta Romana 12 lei in toata tara.

PLATA

  • - Ramburs

Politica de retur

  • - Produsul nu se poate returna.
Fii primul care scrie un review

Spune-ti parerea acordand o nota produsului

Adauga review

Nu ai gasit ce cautai?

Ar putea sa te intereseze

Cautari populare in Display LCD telefon

Top branduri in Display LCD telefon